How To: Replace Clutch Master Cylinder

Tools Needed:

• 3/8 Drive Ratchet
  
• 12MM Socket
  
• 12MM Wrench
  
• 14MM Wrench
  
• 10MM Wrench
  

Parts Needed:

• Clutch Master Cylinder
  

Step 1: Remove these (2) 12MM bolts from the firewall. (Yes, I had already removed them in this pic)



Step 2: Pull this hose clamp off and then remove the hose from the fluid resivor. Sit your resivor aside.





Step 3: Remove your line from the master cylinder.



Step 4: Remove this 12MM nut.



Now, from inside the car...

Step 6: Remove the banjo bolt pin from the clutch pedal. Then remove the pin. Don't lose the washer!



Step 7: Remove this 12MM nut.



These are what you should have removed from the inside of the car.



Step 8: Remove clutch master cylinder.



Step 9: Remove the hose from the old clutch master cylinder. Don't lose the gasket! Your new clutch master cylinder probably won't come with a new one.



Installation of the new clutch master cylinder is reverse of installation.

For information on the clutch petal adjustment, see this thread. http://www.eatsleepdsm.com/t110-how-to-properly-adjust-your-clutch-on-a-2g-1g-evo